Hypertherm 005130 Pressure Switch

Part Description

The Hypertherm 005130 is a pressure switch used in a variety of their plasma cutting systems. It is a normally closed switch, meaning that it is closed when there is no pressure and open when there is pressure. The switch is rated for a maximum pressure of 150 PSI.

Specifications

• Brand: Hypertherm
• Part number: 005130
• Part description: Pressure Switch
• Type: Normally closed
• Maximum pressure: 150 PSI

Installation

The Hypertherm 005130 pressure switch is typically installed in the air line between the compressor and the plasma cutter. It is important to install the switch in a location where it will not be damaged by heat or vibration. The switch should also be installed in a location where it is easily accessible for maintenance.

Troubleshooting

If the Hypertherm 005130 pressure switch is not working properly, it can be tested using a multimeter. The switch should be closed when there is no pressure and open when there is pressure. If the switch is not working properly, it should be replaced.

Replacement

The Hypertherm 005130 pressure switch can be replaced by a qualified technician. When replacing the switch, be sure to use the correct replacement part. The replacement switch should be installed in the same location as the original switch.

Safety Precautions

When working on the Hypertherm 005130 pressure switch, be sure to follow all safety precautions. This includes wearing safety glasses, gloves, and other protective clothing. It is also important to make sure that the plasma cutter is turned off and disconnected from the power supply before working on the switch.