Hypertherm 005231 PS2 Pressure Switch

Part Description

The Hypertherm 005231 PS2 Pressure Switch is a replacement part for Hypertherm plasma cutters. It is used to control the air pressure in the plasma cutting torch. The switch is rated for a maximum pressure of 150 PSI.

Specifications

• Brand: Hypertherm
• Part Number: 005231
• Part Description: PS2 Pressure Switch
• Maximum Pressure: 150 PSI

Installation

To install the Hypertherm 005231 PS2 Pressure Switch, follow these steps:

1. Turn off the plasma cutter and disconnect the power cord.
2. Remove the old pressure switch by unscrewing it from the plasma cutter.
3. Screw the new pressure switch into the plasma cutter.
4. Reconnect the power cord and turn on the plasma cutter.

Troubleshooting

If the Hypertherm 005231 PS2 Pressure Switch is not working properly, check the following:

• Make sure that the pressure switch is properly installed.
• Check the air pressure in the plasma cutting torch.
• Check the air filter in the plasma cutting torch.
• Check the air lines for leaks.

If the pressure switch is still not working properly, contact Hypertherm for assistance.

Conclusion

The Hypertherm 005231 PS2 Pressure Switch is a critical part of the plasma cutting torch. It is important to keep the switch in good working order to ensure the safe and efficient operation of the plasma cutter.

Similar Parts

128616
KIT:PRESSURE SWITCH UNCAL OLD part #005093

005233
PS2 - Switch, pressure, 0-90 psi

228337
KIT:HPR Control Board Replacement PCB3 Old part # 041909 USE NEW PART # 228548

003249
Contactor for HSD/130 NOT for a 260 OLD PART # 003139

128789
Chopper for Max200 old part 129118

128858
KIT:PLT LT REPL - GRN old part# 129633

041909
superseded NEW PART # 228548 PCB3 Control Board for HPR ORDER NEW PART # 228337

128654
obsolete USE PART # 128239 Bullet replacement kit for torch -USE PART # 128239

127155
**WE HAVE AT CSI** Pressure Switch:Break Away C-THC for collision device

005239
26 PSI Assending Pressure Switch