Hypertherm 001160 Air Regulator Mounting Bracket

Part Description

The Hypertherm 001160 air regulator mounting bracket is a component of the Hypertherm Powermax plasma cutting system. It is used to mount the air regulator to the plasma cutter. The air regulator controls the flow of air to the plasma torch.

Specifications

The Hypertherm 001160 air regulator mounting bracket is made of steel. It has a black oxide finish. The bracket measures 3.5" x 2.5" x 1".

Installation

The Hypertherm 001160 air regulator mounting bracket can be installed by following these steps:

1. Disconnect the power to the plasma cutter.
2. Remove the side panel of the plasma cutter.
3. Locate the air regulator mounting bracket.
4. Attach the air regulator mounting bracket to the plasma cutter using the supplied hardware.
5. Reinstall the side panel of the plasma cutter.
6. Reconnect the power to the plasma cutter.

Troubleshooting

If the air regulator is not working properly, it may be necessary to replace the air regulator mounting bracket. To replace the air regulator mounting bracket, follow these steps:

1. Disconnect the power to the plasma cutter.
2. Remove the side panel of the plasma cutter.
3. Locate the air regulator mounting bracket.
4. Remove the air regulator mounting bracket using the supplied hardware.
5. Install the new air regulator mounting bracket using the supplied hardware.
6. Reinstall the side panel of the plasma cutter.
7. Reconnect the power to the plasma cutter.

Conclusion

The Hypertherm 001160 air regulator mounting bracket is a critical component of the Hypertherm Powermax plasma cutting system. It is important to keep the air regulator mounting bracket clean and free of debris. If the air regulator mounting bracket is damaged, it should be replaced immediately.