Hypertherm 228781 KIT:ARCGLIDE RESISTOR CAPACITOR FILTER

Product Description

The Hypertherm 228781 KIT:ARCGLIDE RESISTOR CAPACITOR FILTER is a replacement part for Hypertherm plasma cutting systems. This kit includes the following components:

• One (1) arcglide resistor
• One (1) arcglide capacitor
• One (1) arcglide filter

These components work together to provide clean, consistent power to the plasma cutting torch. The arcglide resistor helps to stabilize the arc, while the arcglide capacitor helps to store and release energy. The arcglide filter helps to remove impurities from the plasma gas, which can improve cut quality.

Installation

The Hypertherm 228781 KIT:ARCGLIDE RESISTOR CAPACITOR FILTER can be installed by a qualified technician. The following steps are general guidelines:

1. Turn off the power to the plasma cutting system.
2. Disconnect the plasma cutting torch from the power supply.
3. Remove the old arcglide resistor, capacitor, and filter.
4. Install the new arcglide resistor, capacitor, and filter.
5. Reconnect the plasma cutting torch to the power supply.
6. Turn on the power to the plasma cutting system.

Troubleshooting

If you are experiencing problems with your Hypertherm plasma cutting system, the following troubleshooting tips may help:

• Check the arcglide resistor, capacitor, and filter for damage.
• Clean the arcglide resistor, capacitor, and filter.
• Replace the arcglide resistor, capacitor, or filter if necessary.

Ordering Information

The Hypertherm 228781 KIT:ARCGLIDE RESISTOR CAPACITOR FILTER can be ordered from your local Hypertherm dealer.