Hypertherm 228200 Kit: Sensor PHC Processor PCB Assy

Description

The Hypertherm 228200 Kit: Sensor PHC Processor PCB Assy is a replacement part for Hypertherm plasma cutting systems. This kit includes the following components:

• Sensor PHC Processor PCB Assy
• Mounting hardware
• Installation instructions

Specifications

• Brand: Hypertherm
• Part number: 228200
• Part description: Kit: Sensor PHC Processor PCB Assy
• Weight: 0.5 lbs
• Dimensions: 6 x 4 x 2 inches

Compatibility

The Hypertherm 228200 Kit: Sensor PHC Processor PCB Assy is compatible with the following Hypertherm plasma cutting systems:

• Powermax45XP
• Powermax65XP
• Powermax85XP
• Powermax105XP
• Powermax125XP

Installation

The Hypertherm 228200 Kit: Sensor PHC Processor PCB Assy can be installed by following these steps:

1. Disconnect the power supply from the plasma cutting system.
2. Remove the old Sensor PHC Processor PCB Assy.
3. Install the new Sensor PHC Processor PCB Assy.
4. Reconnect the power supply to the plasma cutting system.
5. Test the plasma cutting system to ensure that it is working properly.

Troubleshooting

If you are experiencing problems with the Hypertherm 228200 Kit: Sensor PHC Processor PCB Assy, you can try the following troubleshooting steps:

• Check the connections between the Sensor PHC Processor PCB Assy and the plasma cutting system.
• Make sure that the Sensor PHC Processor PCB Assy is properly seated in its slot.
• Update the firmware on the plasma cutting system.
• Contact Hypertherm technical support for assistance.

Conclusion

The Hypertherm 228200 Kit: Sensor PHC Processor PCB Assy is a critical component of Hypertherm plasma cutting systems. This kit can be easily installed and replaced, and it can help to ensure that your plasma cutting system is operating properly.