Hypertherm 228171 Pump for HPR 260/400

Product Description

The Hypertherm 228171 Pump for HPR 260/400 is a genuine OEM replacement part for Hypertherm Powermax plasma cutting systems. This pump is responsible for circulating the coolant through the plasma torch to keep it cool during operation. The pump is rated for a maximum pressure of 100 psi and a flow rate of 5 gallons per minute. It is important to use a genuine OEM replacement pump to ensure that your plasma cutting system is operating properly and safely.

Features

• Genuine OEM replacement part
• Rated for a maximum pressure of 100 psi
• Flow rate of 5 gallons per minute
• Keeps the plasma torch cool during operation
• Easy to install

Compatibility

The Hypertherm 228171 Pump for HPR 260/400 is compatible with the following Hypertherm Powermax plasma cutting systems:

• Powermax 260
• Powermax 400

Installation

The Hypertherm 228171 Pump for HPR 260/400 is easy to install. Simply follow these steps:

1. Disconnect the power supply from the plasma cutting system.
2. Remove the old pump from the plasma cutting system.
3. Install the new pump onto the plasma cutting system.
4. Reconnect the power supply to the plasma cutting system.

Troubleshooting

If you are experiencing problems with the Hypertherm 228171 Pump for HPR 260/400, please refer to the following troubleshooting tips:

• Check the pump for leaks.
• Check the pump's pressure and flow rate.
• Check the pump's electrical connections.
• If the pump is still not working, contact Hypertherm technical support for assistance.

Conclusion

The Hypertherm 228171 Pump for HPR 260/400 is an essential part of your Hypertherm Powermax plasma cutting system. This pump is responsible for circulating the coolant through the plasma torch to keep it cool during operation. It is important to use a genuine OEM replacement pump to ensure that your plasma cutting system is operating properly and safely.