Hypertherm 220304 Nozzle / Ret. Cap

Product Details

• Brand: Hypertherm
• Part number: 220304
• Description: Nozzle / Ret. Cap
• Material: Copper
• Dimensions: 1.125" OD x 0.875" H
• Weight: 0.1 lbs

Features

• Provides a smooth, even flow of shielding gas to the cutting area
• Helps to protect the electrode from damage
• Extends the life of the electrode and nozzle
• Easy to install and replace

Compatibility

• Hypertherm Powermax45 XP
• Hypertherm Powermax65 XP
• Hypertherm Powermax85 XP
• Hypertherm Powermax105 XP
• Hypertherm Powermax125 XP

Installation

1. Remove the old nozzle and retaining cap.
2. Clean the area around the nozzle seat.
3. Apply a small amount of anti-seize compound to the threads of the new nozzle.
4. Screw the new nozzle into the nozzle seat.
5. Tighten the nozzle until it is snug.
6. Install the new retaining cap.

Maintenance

• Inspect the nozzle and retaining cap for damage before each use.
• Replace the nozzle and retaining cap if they are damaged.
• Clean the nozzle and retaining cap with a soft cloth after each use.

Troubleshooting

If you are experiencing problems with your Hypertherm plasma cutter, the nozzle and retaining cap may be the cause. Here are some troubleshooting tips:

• Check the nozzle and retaining cap for damage. If they are damaged, replace them.
• Clean the nozzle and retaining cap with a soft cloth.
• Make sure the nozzle is properly installed.
• Make sure the retaining cap is properly installed.
• If you are still experiencing problems, contact Hypertherm customer service for assistance.