Hypertherm 141201 PRINTED CIRCUIT BOARD ASSEMBLY:VDC 3

Product Description

The Hypertherm 141201 PRINTED CIRCUIT BOARD ASSEMBLY:VDC 3 is a genuine Hypertherm replacement part.

Compatibility

This part is compatible with the following Hypertherm plasma cutters:

• Powermax30 XP
• Powermax45 XP
• Powermax65 XP
• Powermax85 XP
• Powermax105 XP
• Powermax125 XP

Installation

To install the Hypertherm 141201 PRINTED CIRCUIT BOARD ASSEMBLY:VDC 3, follow these steps:

1. Disconnect the power supply from the plasma cutter.
2. Remove the side panel of the plasma cutter.
3. Locate the old PRINTED CIRCUIT BOARD ASSEMBLY:VDC 3.
4. Remove the old PRINTED CIRCUIT BOARD ASSEMBLY:VDC 3 by disconnecting the wires and unscrewing the mounting screws.
5. Install the new PRINTED CIRCUIT BOARD ASSEMBLY:VDC 3 by connecting the wires and screwing in the mounting screws.
6. Replace the side panel of the plasma cutter.
7. Reconnect the power supply to the plasma cutter.

Troubleshooting

If the Hypertherm 141201 PRINTED CIRCUIT BOARD ASSEMBLY:VDC 3 is not working properly, check the following:

• The wires are properly connected.
• The mounting screws are tight.
• The PRINTED CIRCUIT BOARD ASSEMBLY:VDC 3 is not damaged.

If the problem persists, contact Hypertherm technical support for assistance.

Conclusion

The Hypertherm 141201 PRINTED CIRCUIT BOARD ASSEMBLY:VDC is a critical component of your Hypertherm plasma cutter. By following these steps, you can easily install and troubleshoot this part.