Hypertherm 128985 Ignition Console Coolant Hose Set, 65 ft

Product Description

The Hypertherm 128985 Ignition Console Coolant Hose Set is a replacement part for Hypertherm plasma cutting systems. This hose set includes 65 feet of coolant hose, as well as all of the necessary fittings and connectors. The hose is made of a durable, high-quality material that is resistant to chemicals and abrasion. This hose set is designed to provide a long service life, even in the most demanding cutting environments.

Features

• 65 feet of coolant hose
• All necessary fittings and connectors
• Durable, high-quality material
• Resistant to chemicals and abrasion
• Long service life

Applications

The Hypertherm 128985 Ignition Console Coolant Hose Set is compatible with the following Hypertherm plasma cutting systems:

• Powermax30 XP
• Powermax45 XP
• Powermax65 XP
• Powermax85 XP
• Powermax105 XP
• Powermax125 XP

Installation

The Hypertherm 128985 Ignition Console Coolant Hose Set can be installed by following these steps:

1. Disconnect the power supply from the plasma cutting system.
2. Remove the old coolant hose set.
3. Install the new coolant hose set, making sure to connect the fittings and connectors correctly.
4. Reconnect the power supply to the plasma cutting system.
5. Test the coolant flow to make sure that it is working properly.

Maintenance

The Hypertherm 128985 Ignition Console Coolant Hose Set should be inspected regularly for signs of wear or damage. If any damage is found, the hose set should be replaced immediately. The hose set should also be cleaned periodically to remove any dirt or debris that may have accumulated.

Troubleshooting

If the coolant flow is not working properly, there are a few things that you can check:

• Make sure that the coolant hose set is properly installed.
• Check the coolant level in the reservoir.
• Check the coolant pump to make sure that it is working properly.
• If the problem persists, contact Hypertherm technical support for assistance.

Conclusion

The Hypertherm 128985 Ignition Console Coolant Hose Set is a critical part of your Hypertherm plasma cutting system. This hose set is designed to provide a long service life, even in the most demanding cutting environments. By following the installation and maintenance instructions, you can help to ensure that your coolant hose set will perform properly and last for many years.