Hypertherm 128878 Consumable Parts Kit for HPR130
Overview
The Hypertherm 128878 consumable parts kit for the HPR130 plasma cutting system includes the following items:
- 1 x Retaining Cap (220612)
- 1 x Shield Cap (220609)
- 1 x Nozzle (220594)
- 1 x Electrode (220592)
- 1 x Swirl Ring (220260)
These parts are essential for maintaining optimal cutting performance and extending the life of your HPR130 plasma cutting system.
Installation
To install the consumable parts, follow these steps:
- Turn off the power to the plasma cutting system.
- Remove the old consumable parts.
- Install the new consumable parts.
- Tighten the retaining cap until it is snug.
- Turn on the power to the plasma cutting system.
Maintenance
To ensure optimal cutting performance and extend the life of your consumable parts, it is important to follow these maintenance procedures:
- Inspect the consumable parts before each use.
- Replace any consumable parts that are damaged or worn.
- Clean the consumable parts after each use.
- Store the consumable parts in a cool, dry place.
Troubleshooting
If you are experiencing problems with your HPR130 plasma cutting system, check the following:
- Make sure that the consumable parts are installed correctly.
- Make sure that the consumable parts are not damaged or worn.
- Make sure that the plasma cutting system is properly grounded.
- Make sure that the plasma cutting system is receiving the correct power supply.
If you are still experiencing problems, contact Hypertherm technical support for assistance.
Similar Parts
228368
HPR 400 XD AL/SS Consumable Parts Kit
028392
Consumable PArts Kit - Standard
850810
Marketing Sample - HPR 260 XD consumable parts kit, Manual gas
228421
KIT-PARTKIT:HPR130 SS/AL CONSUMABLE STARTER
128059
Arc Writer consumable parts kit
028602
Standard Consumable Parts Kit, HT2000 and HT2000LHF
228367
HPR 400 XD MS Consumable Parts Kit
228027
HPR 260 Consumable Parts Kit
128825
HySpeed HT2000 Consumable Parts
428013
KIT:MAXPRO200 MECHANIZED CUTTING PARTS KIT