Hypertherm 128184 Roller Ball Lifter Assembly

Part Description

The Hypertherm 128184 Roller Ball Lifter Assembly is a replacement part for the Hypertherm Arc Writer. It replaces part #129196. The Roller Ball Lifter Assembly is responsible for lifting the arc writer off the cutting surface. This prevents the arc writer from dragging on the surface and damaging the material being cut.

Specifications

The Hypertherm 128184 Roller Ball Lifter Assembly has the following specifications:

• Material: Stainless steel
• Dimensions: 1.5" x 0.5" x 0.5"
• Weight: 0.5 oz

Installation

To install the Hypertherm 128184 Roller Ball Lifter Assembly, follow these steps:

1. Remove the old Roller Ball Lifter Assembly from the Arc Writer.
2. Clean the mounting surface of the Arc Writer.
3. Apply a small amount of grease to the new Roller Ball Lifter Assembly.
4. Position the new Roller Ball Lifter Assembly on the Arc Writer.
5. Secure the Roller Ball Lifter Assembly with the two screws provided.

Maintenance

The Hypertherm 128184 Roller Ball Lifter Assembly requires minimal maintenance. However, it is important to inspect the assembly regularly for wear and tear. If the assembly is damaged, it should be replaced immediately.

Troubleshooting

If the Hypertherm 128184 Roller Ball Lifter Assembly is not working properly, there are a few things you can check:

• Make sure that the assembly is installed correctly.
• Check the assembly for wear and tear.
• Clean the assembly and the mounting surface of the Arc Writer.
• If the problem persists, contact Hypertherm customer support.