Hypertherm 123221 IHS Ohmic Contact Wire

Product Description

The Hypertherm 123221 IHS Ohmic Contact Wire is a 25 ft (7.6m) long wire used to make electrical contact with the IHS (integrated heat sink) of a Hypertherm plasma cutting torch. The wire is made of a flexible, high-conductivity material that can withstand the high temperatures and currents generated by the plasma cutting process.

Specifications

• Brand: Hypertherm
• Part number: 123221
• Part description: IHS Ohmic Contact Wire
• Length: 25 ft (7.6m)
• Material: Flexible, high-conductivity material

Installation

The Hypertherm 123221 IHS Ohmic Contact Wire can be installed by following these steps:

1. Disconnect the power to the plasma cutting torch.
2. Remove the old IHS ohmic contact wire.
3. Clean the IHS contact surface with a solvent.
4. Apply a thin layer of thermal grease to the IHS contact surface.
5. Install the new IHS ohmic contact wire.
6. Reconnect the power to the plasma cutting torch.

Safety Precautions

When working with the Hypertherm 123221 IHS Ohmic Contact Wire, it is important to take the following safety precautions:

• Always wear safety glasses when working with electrical components.
• Do not touch the IHS ohmic contact wire while the plasma cutting torch is powered on.
• Be aware of the potential for electrical shock when working with the IHS ohmic contact wire.