Hypertherm 120185 Shield Cap

Part Description

The Hypertherm 120185 shield cap is a replacement part for the Hypertherm HT2000 plasma cutter. It is made of durable materials and is designed to protect the torch from damage. The shield cap is easy to install and can be replaced in a matter of minutes.

Specifications

• Brand: Hypertherm
• Part Number: 120185
• Part Description: Shield Cap, HT2000, 50 amp

Installation Instructions

To install the Hypertherm 120185 shield cap, follow these steps:

1. Turn off the power to the plasma cutter.
2. Remove the old shield cap by unscrewing it from the torch.
3. Screw the new shield cap onto the torch.
4. Tighten the shield cap until it is snug.
5. Turn on the power to the plasma cutter.

Troubleshooting

If the Hypertherm 120185 shield cap is not installed correctly, it can cause the torch to malfunction. If you are experiencing problems with your torch, check the shield cap to make sure that it is installed correctly.

Conclusion

The Hypertherm 120185 shield cap is an important part of the Hypertherm HT2000 plasma cutter. It is made of durable materials and is designed to protect the torch from damage. The shield cap is easy to install and can be replaced in a matter of minutes.

Similar Parts

120186
Shield, HT2000, 50 amp

020336
Shield Cap, 100 Amp

C107-274
Shield Cap, 200 Amp, MS/SS/AL

C107-263
Shield Cap, 275 Amp, MS/SS/AL

C107-150
Shield Cap, 70 Amp, MS/SS/AL

C107-149
Shield Cap, 50 Amp, SS, Air

C107-144
Shield Cap, 30 Amp, SS, Air

C107-117
Shield Cap, 150 Amp, MS/SS/AL

C107-115
Shield Cap, 50 Amp, MS

020699
Gouging Shield Cap 100 Amp