Hypertherm 031122
CPLR:PRO PUMP-MOT
This is a replacement part for Hypertherm Powermax plasma cutters.
Compatibility
This part is compatible with the following Hypertherm plasma cutters:
- Powermax30 XP
- Powermax45 XP
- Powermax65 XP
- Powermax85 XP
- Powermax105 XP
- Powermax125 XP
Installation
To install this part, follow these steps:
- Disconnect the power from the plasma cutter.
- Remove the old part.
- Install the new part.
- Reconnect the power to the plasma cutter.
Troubleshooting
If you are experiencing problems with your Hypertherm plasma cutter, here are some troubleshooting tips:
- Check the power cord to make sure it is properly connected.
- Check the air filter to make sure it is clean.
- Check the torch to make sure it is properly installed.
- Check the ground clamp to make sure it is properly connected.
If you are still experiencing problems, contact Hypertherm customer service for assistance.
Ordering Information
To order this part, contact your local Hypertherm dealer.
Warranty
This part is covered by a 1-year warranty.
Similar Parts
428305
KIT:EDGE PRO/MICROEDGE PRO SERCOS PCI SLOT
028626
LEADS: HT2000 GAS CSL/MOT-V 30
228119
EDGE TI LIFTER W/MOT/ENCDR/BRK/MAG BRK-AWAY ASSY-0218
228117
PHC LIFTER ASSY:W/MOT/BRK/MAG BRK-AWAY ASSY-0224
129999
MOT-V SA:HPR AUTO GAS SEL
128385
KIT:MOT W/CLP 1/3HP
123898
CABLE:MOT PWR/BRAKE 50' HTA# CABL-0254
123902
CABLE:LIFTER MOT/BRAKE PWR 15.25 m 50 ft
028852
LEADS: HT 2000 GAS CSL/MOT-V 61'
073069
HT2000 MOT-VALVE CSL