Hypertherm 027552 Driving Block

Part Description

The Hypertherm 027552 Driving Block is a component of the Hypertherm Powermax125 plasma cutter. It is responsible for driving the torch along the cutting path. The driving block is a precision-machined component that is made of high-quality materials to ensure durability and long life.

Part Number

The part number for the Hypertherm 027552 Driving Block is 027552.

Compatibility

The Hypertherm 027552 Driving Block is compatible with the following Hypertherm plasma cutters:

• Powermax125

Installation

The Hypertherm 027552 Driving Block can be installed by following these steps:

1. Disconnect the power from the plasma cutter.

2. Remove the old driving block.

3. Install the new driving block.

4. Reconnect the power to the plasma cutter.

Troubleshooting

If you are experiencing problems with the Hypertherm 027552 Driving Block, you can try the following troubleshooting steps:

• Check the connections between the driving block and the plasma cutter.

• Make sure that the driving block is properly installed.

• Clean the driving block and the torch.

• Replace the driving block.