Hypertherm 020712 Shield 100 Amp

Product Description

The Hypertherm 020712 Shield 100 Amp is a replacement part for Hypertherm plasma cutters. It is made of durable materials and is designed to protect the torch from damage. The shield is easy to install and can be replaced quickly and easily.

Features

Protects the torch from damage
Durable materials
Easy to install
Quick and easy replacement

Specifications

Brand: Hypertherm
Part number: 020712
Part description: Shield 100 Amp

Compatibility

The Hypertherm 020712 Shield 100 Amp is compatible with the following Hypertherm plasma cutters:

Powermax30 XP
Powermax45 XP
Powermax65 XP
Powermax85 XP
Powermax105 XP
Powermax125 XP

Installation

To install the Hypertherm 020712 Shield 100 Amp, follow these steps:

Turn off the plasma cutter and disconnect the power cord.
Remove the old shield by unscrewing the two screws that hold it in place.
Position the new shield over the torch and align the screw holes.
Insert the screws and tighten them until the shield is secure.

Maintenance

To maintain the Hypertherm 020712 Shield 100 Amp, follow these steps:

Inspect the shield for damage before each use.
Clean the shield with a mild detergent and water after each use.
Replace the shield if it is damaged.

Troubleshooting

If the Hypertherm 020712 Shield 100 Amp is not working properly, check the following:

Make sure that the shield is properly installed.
Make sure that the shield is not damaged.
Clean the shield with a mild detergent and water.
If the shield is still not working properly, contact Hypertherm customer service.

Similar Parts

020335
Shield, Hand, 100 Amp

020334
Shield, Machine, 100 Amp

120273
100 amp shield, Hypertherm HD3070

020336
Shield Cap, 100 Amp

020699
Gouging Shield Cap 100 Amp

123218
Plasma, Machine and Lifter I/O, 100 ft. CABLE:37-POSN MALE/FEM DSUB 30M/100'

220047
PowerMax 1650 Shield 100 A

120785
Electrode, HyLife, O2, 100 Amp

120777
Nozzle, Shielded, O2, 100 Amp

120592
100 amp retaining cap, Hypertherm HD3070