Hypertherm 020546 Nozzle: PAC 120/121

Description

The Hypertherm 020546 is a nozzle for the PAC 120 and PAC 121 plasma cutters. It is made of copper and has a 1.2 mm orifice. The nozzle is used to focus the plasma arc and protect the electrode from damage.

Specifications

• Brand: Hypertherm
• Part number: 020546
• Part description: Nozzle: PAC 120/121
• Material: Copper
• Orifice: 1.2 mm

Compatibility

The Hypertherm 020546 nozzle is compatible with the following plasma cutters:

• Hypertherm PAC 120
• Hypertherm PAC 121

Installation

To install the Hypertherm 020546 nozzle, follow these steps:

1. Turn off the plasma cutter and disconnect the power cord.
2. Remove the old nozzle by unscrewing it from the torch body.
3. Screw the new nozzle onto the torch body.
4. Tighten the nozzle until it is snug.
5. Reconnect the power cord and turn on the plasma cutter.

Maintenance

The Hypertherm 020546 nozzle should be inspected regularly for wear and tear. If the nozzle is damaged, it should be replaced immediately. To extend the life of the nozzle, it is important to clean it after each use. To clean the nozzle, follow these steps:

1. Turn off the plasma cutter and disconnect the power cord.
2. Remove the nozzle from the torch body.
3. Use a soft brush to remove any debris from the nozzle.
4. Rinse the nozzle with water.
5. Dry the nozzle with a clean cloth.
6. Reinstall the nozzle on the torch body.

Troubleshooting

If the plasma cutter is not cutting properly, the nozzle may be damaged. Check the nozzle for wear and tear and replace it if necessary. If the nozzle is not damaged, the problem may be with the plasma cutter itself. Consult the plasma cutter's manual for troubleshooting tips.