Hypertherm 011061 Flow Tube

Part Description

The Hypertherm 011061 flow tube is a расходный материал used with the Hypertherm HD3070 manual gas console. The flow tube is responsible for delivering the shielding gas to the cutting torch. It is made of a durable material that is resistant to heat and corrosion. The flow tube is easy to install and replace.

Specifications

• Part Number: 011061
• Brand: Hypertherm
• Material: Stainless Steel

Compatibility

The Hypertherm 011061 flow tube is compatible with the following Hypertherm systems:

• HD3070 Manual Gas Console

Installation

The Hypertherm 011061 flow tube can be installed by following these steps:

1. Turn off the power to the plasma cutter.
2. Disconnect the gas hose from the plasma cutter.
3. Remove the old flow tube from the plasma cutter.
4. Install the new flow tube into the plasma cutter.
5. Reconnect the gas hose to the plasma cutter.
6. Turn on the power to the plasma cutter.

Replacement

The Hypertherm 011061 flow tube should be replaced when it becomes damaged or worn. To replace the flow tube, follow the steps outlined in the installation section.

Troubleshooting

If you are experiencing problems with the Hypertherm 011061 flow tube, you can try the following troubleshooting steps:

• Check the gas hose for leaks.
• Make sure the flow tube is properly installed.
• Replace the flow tube if it is damaged or worn.

If you are still experiencing problems, you can contact Hypertherm technical support for assistance.