Hypertherm 011008 Plastic Shield for Flow Meter

Overview

The Hypertherm 011008 Plastic Shield for Flow Meter is a replacement part for Hypertherm plasma cutting systems. It is made of durable plastic and protects the flow meter from damage. The shield is easy to install and remove, and it does not require any special tools.

Specifications

• Brand: Hypertherm
• Part number: 011008
• Part description: Plastic Shield for Flow Meter
• Material: Plastic
• Dimensions: 2.5" x 2.5" x 1"
• Weight: 0.5 ounces

Compatibility

The Hypertherm 011008 Plastic Shield for Flow Meter is compatible with the following Hypertherm plasma cutting systems:

• Powermax30 XP
• Powermax45 XP
• Powermax65 XP
• Powermax85 XP
• Powermax105 XP
• Powermax125 XP

Installation

To install the Hypertherm 011008 Plastic Shield for Flow Meter, follow these steps:

1. Turn off the plasma cutting system and disconnect the power cord.
2. Remove the old shield by unscrewing the two screws that hold it in place.
3. Position the new shield over the flow meter and insert the two screws.
4. Tighten the screws until the shield is secure.

Removal

To remove the Hypertherm 011008 Plastic Shield for Flow Meter, follow these steps:

1. Turn off the plasma cutting system and disconnect the power cord.
2. Unscrew the two screws that hold the shield in place.
3. Remove the shield from the flow meter.

Cleaning

The Hypertherm 011008 Plastic Shield for Flow Meter can be cleaned with a mild detergent and water. Do not use any harsh chemicals or abrasives, as these can damage the shield.

Troubleshooting

If the Hypertherm 011008 Plastic Shield for Flow Meter is damaged, it should be replaced immediately. A damaged shield can allow dirt and debris to enter the flow meter, which can cause it to malfunction.

Conclusion

The Hypertherm 011008 Plastic Shield for Flow Meter is an important part of your plasma cutting system. It protects the flow meter from damage and helps to ensure that your system operates properly.