Hypertherm 009296 Surge Cap

Part description

The Hypertherm 009296 Surge Cap is a replacement part for Hypertherm plasma cutters. It is designed to protect the torch from damage caused by electrical surges. The surge cap is made of a durable material that can withstand high temperatures and electrical currents. It is easy to install and replace.

Specifications

• Brand: Hypertherm
• Part number: 009296
• Description: Surge Cap
• Material: Copper
• Dimensions: 1.5" x 0.5" x 0.5"
• Weight: 0.5 oz

Installation

To install the Hypertherm 009296 Surge Cap, follow these steps:

1. Turn off the power to the plasma cutter.
2. Remove the old surge cap from the torch.
3. Install the new surge cap on the torch.
4. Tighten the surge cap until it is snug.
5. Turn on the power to the plasma cutter.

Maintenance

The Hypertherm 009296 Surge Cap does not require any maintenance. However, it should be inspected regularly for signs of damage. If the surge cap is damaged, it should be replaced immediately.

Troubleshooting

If the Hypertherm 009296 Surge Cap is not working properly, there are a few things you can check:

• Make sure that the surge cap is installed correctly.
• Check the surge cap for signs of damage.
• Make sure that the torch is properly grounded.
• If the problem persists, contact Hypertherm customer service.

Conclusion

The Hypertherm 009296 Surge Cap is an important part of the plasma cutting system. It helps to protect the torch from damage caused by electrical surges. The surge cap is easy to install and maintain. If you have any questions about the Hypertherm 009296 Surge Cap, please contact Hypertherm customer service.