Hypertherm 008328 Knob

Part Description

The Hypertherm 008328 Knob is a genuine replacement part for Hypertherm plasma cutters. This knob is used to control the amperage output of the plasma cutter. It is made of durable plastic and is easy to install.

Specifications

• Brand: Hypertherm
• Part Number: 008328
• Description: Knob
• Material: Plastic
• Color: Black
• Weight: 0.1 ounces
• Dimensions: 1.5 x 1.5 x 1 inches

Compatibility

The Hypertherm 008328 Knob is compatible with the following Hypertherm plasma cutters:

• Powermax30 XP
• Powermax45 XP
• Powermax65 XP
• Powermax85 XP
• Powermax105 XP
• Powermax125 XP

Installation

To install the Hypertherm 008328 Knob, follow these steps:

1. Turn off the plasma cutter and disconnect it from the power source.
2. Remove the old knob by pulling it straight off of the shaft.
3. Slide the new knob onto the shaft.
4. Tighten the knob until it is snug.
5. Reconnect the plasma cutter to the power source and turn it on.

Troubleshooting

If the Hypertherm 008328 Knob is not working properly, check the following:

• Make sure that the knob is properly installed.
• Check the connections between the plasma cutter and the power source.
• Check the amperage output of the plasma cutter.
• If the problem persists, contact Hypertherm customer service.

Conclusion

The Hypertherm 008328 Knob is a genuine replacement part that is essential for the proper operation of your Hypertherm plasma cutter. It is easy to install and can be replaced in a matter of minutes.