Monthly Basis
What's happening this month?

Hypertherm 006112

Part Description

The Hypertherm 006112 is a solenoid coil that is used in a variety of plasma cutting torches. It is a replacement part for the 006106 and 006109 solenoid coils. The 006112 is no longer in production and has been replaced by the 006109 solenoid coil.

Specifications

The 006112 solenoid coil has the following specifications:

  • Voltage: 24 VDC
  • Current: 1.5 A
  • Resistance: 16 ohms
  • Inductance: 1.5 mH
  • Weight: 0.5 lbs

Applications

The 006112 solenoid coil is used in the following Hypertherm plasma cutting torches:

  • Powermax30
  • Powermax45
  • Powermax65
  • Powermax85
  • Powermax105
  • Powermax125

Installation

The 006112 solenoid coil can be installed in a Hypertherm plasma cutting torch by following these steps:

  1. Disconnect the power from the plasma cutting torch.
  2. Remove the side panel of the plasma cutting torch.
  3. Locate the solenoid coil.
  4. Remove the two screws that hold the solenoid coil in place.
  5. Remove the old solenoid coil.
  6. Install the new solenoid coil.
  7. Replace the two screws that hold the solenoid coil in place.
  8. Replace the side panel of the plasma cutting torch.
  9. Reconnect the power to the plasma cutting torch.

Troubleshooting

If the 006112 solenoid coil is not working properly, it can be troubleshooted by following these steps:

  1. Check the power supply to the solenoid coil.
  2. Check the continuity of the solenoid coil.
  3. Check the resistance of the solenoid coil.
  4. Check the inductance of the solenoid coil.

If any of these tests fail, the solenoid coil should be replaced.

Conclusion

The Hypertherm 006112 solenoid coil is a critical component of a Hypertherm plasma cutting torch. It is important to keep the solenoid coil in good working order to ensure the proper operation of the plasma cutting torch.

Similar Parts

109393
FOR HPR130, HPR260 & HSD130, ORDER P/N 229408; FOR HPR400 & HPR800, ORDER P/N 229224 ...

027012
THIS ITEM HAS BEEN DISCONTINUED - order 027055 Lubricant, Sil., 2-oz. Tube

420158
NOZZLE:DURAMAX HYAMP 45A CUT, order in qtys of 5

123851
*DO NOT ORDER* Cable: CNC Interfac, 20 m/65 ft.

041909
superseded NEW PART # 228548 PCB3 Control Board for HPR ORDER NEW PART # 228337

041706
Command THC Control Board upgraded board ** MUST ORDER KIT#128407

123742
**DO NOT ORDER** Cable: CNC Interface, 35m/115' Posn Male/Female Dsub

040212
D: Sol. Coil W-C

229697
CONTACTOR SUBASSEMBLY:80 AMPS IEC AC-3 RATING 3-POLE 120 VOLTS ALTERNATING CURRENT COIL ...

229837
COIL ASSEMBLY:XPR IGNITION