Hypertherm 129563 Off Valve Assembly

Part Description

The Hypertherm 129563 Off Valve Assembly is a replacement part for Hypertherm plasma cutters. This assembly includes the off valve, spring, and O-ring. The off valve assembly is responsible for shutting off the flow of gas to the plasma cutter when the trigger is released.

Specifications

• Part Number: 129563
• Brand: Hypertherm
• Description: Off Valve Assembly
• Material: Brass
• O-Ring Material: Buna-N

Compatibility

The Hypertherm 129563 Off Valve Assembly is compatible with the following Hypertherm plasma cutters:

• Powermax30 XP
• Powermax45 XP
• Powermax65 XP
• Powermax85 XP
• Powermax105 XP
• Powermax125 XP

Installation

To install the Hypertherm 129563 Off Valve Assembly, follow these steps:

1. Turn off the plasma cutter and disconnect the power cord.
2. Remove the old off valve assembly by unscrewing it from the plasma cutter.
3. Apply a small amount of thread sealant to the threads of the new off valve assembly.
4. Screw the new off valve assembly into the plasma cutter.
5. Tighten the off valve assembly until it is snug.
6. Reconnect the power cord and turn on the plasma cutter.

Troubleshooting

If the Hypertherm 129563 Off Valve Assembly is not working properly, check the following:

• Make sure that the off valve assembly is properly installed.
• Check the O-ring for damage and replace it if necessary.
• Check the spring for damage and replace it if necessary.
• If the off valve assembly is still not working properly, contact Hypertherm customer service for assistance.

Conclusion

The Hypertherm 129563 Off Valve Assembly is a critical part of the plasma cutter. By following the installation and troubleshooting instructions in this document, you can ensure that the off valve assembly is working properly and that your plasma cutter is operating at peak performance.